How to measure SWR using Diamond SX SWR meter

Here’s a simple tutorial on how to measure Standing Wave Radio (SWR) for your stations setup using Diamond SX series (SX-200,SX-400,SX-600) SWR meter, commonly available in Malaysia and Singapore.

This guide assume that you are measuring SWR for a VHF antenna operating on 2 meter amateur radio band (144 MHz – 148 MHz), voice FM.

Step 1
Firstly ensure that you’ve connected your rig and antenna to SWR meter securely. Ensure that the “blue button” is not depressed.

Step 2
Find a frequency that is not in use. Ask first to ensure that nobody is using that frequency, never ever perform SWR testing on Repeater input or output frequency.

In northern part of Malaysia, 145.575MHz has been set aside as a testing frequency.

Step 3

Ensure that you set the SWR meter switch setting to CAL as in the photograph.

Make sure your rig is set to transmit on the lowest power level setting acceptable by the SWR meter (usually around 5watt), any interference should be minimized.

Press PTT button and id your station, example “9W2QRT testing…”, make sure you use your own callsign!

without releasing PTT, adjust the CAL knob on the SWR meter until the needle points to red arrow to “CAL”, refer to photographs below.

Step 4

Finally, without releasing PTT, turn the switch on the SWR meter to “SWR”, as shown in photograph :

The meter will display SWR for your antenna setup. In this case 1.5:1. Dont forget to release PTT button after the test. To ensure your antenna is useful accross the band, you can repeat the test on amateur band edge, that is on 144.000 MHz and 148.000MHz.

Final thought
Remember, all test should be brief, and accompanied by your callsign, never ever transmit on repeater inputs or on busy channel.

credit for 9w2wtf

http://please.name.my/129/how-to-measure-swr-using-diamond-sx-swr-meter.html